Pilling happens when skincare rolls into tiny balls on your face, and it can leave makeup looking patchy. The flecks are leftover product, not dead skin. The causes are usually simple: going too fast, putting too much on, rubbing too hard or layering in the wrong order. Three habits fix most of it: wait between layers, pat products in, and keep face oil for the end.
The method, step by step
1. Give each layer time to settle
Dr Calvin Chan, medical director of Calvin Chan Aesthetic & Laser Clinic, made two points in earlier advice. Gel- and alcohol-based products tended to pill when there was sebum on the skin, in the way oil sits on water. And the best way to prevent pilling was to let each layer absorb before applying the next. His practical test was to press your fingertips to your face. If they still felt damp, you waited another two minutes and tested again.
Current guidance follows the same idea. Rushing your routine is one of the most common causes of pilling. Some dermatologists suggest waiting 60 to 90 seconds between skincare steps and a full two minutes before putting on makeup. Wet layers can also make makeup pill.
2. Pat, never rub
Rubbing too hard creates friction, and friction makes products clump. Pressing or patting products in gently avoids this. Rubbing during sunscreen application, foundation blending or touch-ups is often what lifts the film of product and makes it roll.
A massage method from an Estee Lauder Singapore education executive suggested warming about five drops of serum between your palms. You then traced a heart shape from the centre of the face out towards the ears, closed it at the chin and slid your fingers down the sides of the neck. The method was also said to help drain excess fluid from the face.
3. Save face oil for last
Dr Alvin Wong, medical director of SKN Mediaesthetics, advised against putting facial oils under serum, because the oil could stop products layered on top from absorbing. Current advice agrees. Oil-based moisturisers form an occlusive barrier that holds moisture in, but that barrier can also block whatever goes on top. The usual rule is to apply water-based formulas first and oil-based products after them. More generally, skincare goes on from lightest to heaviest texture.
Tips and variations
- Start with a clean face. Leftover makeup, excess sebum and last night’s cream can make your morning products pill, so begin with a thorough cleanse.
- Use less. Too much product leaves extra sitting on the skin, where it can pill. Start with less than you think you need and add more only if you have to. Too much hyaluronic acid is one known culprit.
- Check the labels. Silicones pill easily. So do other film-forming ingredients such as carbomers, which give primers and some skincare their blurred, velvety finish. A silicone-heavy primer under a water-based foundation is a common mismatch.
- Pair similar formulas. Products made with similar bases are less likely to pill when layered than ones that repel each other the way oil and water do.
- Watch your sunscreen. Oil-based SPFs are especially prone to pilling, and makeup on top of sunscreen can turn uneven. Don’t use less sunscreen to stop the pilling. Apply the full amount and fix the layers underneath instead.
- Exfoliate gently. A build-up of dead skin cells can mix with products and stop them absorbing. Harsh exfoliation usually makes pilling worse, though, because it adds irritation and flaking.
- Alternate your routine. Using different products on different days, depending on your skin’s needs, cuts down how many layers go on at once.
When skin needs a break
If your routine leaves skin red, flaky, stinging or itchy, skip products with active ingredients for a few days until your skin calms down. If one product keeps pilling no matter how you layer it, its formula may simply not suit your skin. The fix then is to work out which product it is and drop it from your routine.